Carbery 1150H – Plastic Single Skin Oil Tank

DIMENSIONS, WEIGHTS AND CAPACITIES:

TANK SPECIFICATION INCLUDES: 

• 1 inch BSP bottom mounted tank feed outlet
• Lockable oil tank fill point/inspection aperture
• 2 inch top mounted oil tank vent
• 32mm Pre-drilled hole for ultrasonic remote oil tank gauge

Installation Requirements:

All oil tanks must be installed, and all maintenance carried out by, an Oftec registered engineer in accordance with the supplied instructions. Statutory regulations require that all fuel and oil storage tanks should be installed upon a base of adequate strength that extends a minimum of 300mm beyond the maximum dimensions of the tank in all directions.

RPM Fuels & Tanks will not be responsible for oil tank installations which do not comply with these requirements and where a single skin oil tank has been installed where a bunded tank is a legal requirement. 

IMPORTANT INFORMATION : SINGLE SKIN OIL TANKS: 

Single Skin Oil Tanks do not incorporate any form of secondary containment. Therefore in the event of a spillage, a pollution incident will result. Consideration therefore should always be given to installing a Bunded Oil Tank. Bunded oil storage tanks are proven to significantly reduce the likelihood of a pollution incident, with all the corresponding clean up costs and fines, in the event of an oil leak. Fitting a single skin fuel oil tank where a bunded tank is require is an offence.

Please note that this single skin oil tank is designed for the storage of heating oil, where applicable under statatury requirements, and is NOT suitable as a gravity feed vehicle fueling system. For the re-fuelling of vehicles please see our Carbery Bunded Fuel Point range of diesel tanks.